The use of diamond wire drawing die

In order to ensure high-quality wire and effectively control the cost of mold use, attention should be paid to the following points when using the wire drawing mold

1. To ensure the smooth operation of the wire drawing equipment: the wire drawing drums and the wire guide wheels should be smooth and flexible, and their runout tolerances should be strictly controlled.

If the drum wheel is found, the guide wheel has worn grooves and should be repaired in time.

2. Good lubricating conditions are important conditions to ensure the surface quality of the wire and extend the life of the mold. The lubricating indicators should be checked frequently to remove the copper powder and impurities in the lubricating oil so as not to pollute the equipment and die holes. If the lubrication fails, it must be timely Replace and clean the lubrication system.

3. Reasonable mold matching to ensure the surface quality of the wire, control the size accurately and uniformly, reduce the wear of the drawing drum and reduce the key factors of the equipment operating load. For the sliding wire drawing machine, it is necessary to be familiar with the mechanical elongation of the equipment, and choose the sliding coefficient reasonably, which is the first step of mold matching.

4. Select the die hole type according to the material of the wire to be drawn and the area reduction rate of each wire drawing. Generally speaking, the harder the wire is drawn, the smaller the compression angle of the mold and the longer the sizing area; and vice versa. The area reduction rate of each wire drawing is also closely related to the compression angle of the corresponding mold, and the compression angle should be appropriately adjusted according to the size reduction rate.